DateCityStateEmployerBody PartEvent
2021-10-21KatyTxDyna Drill Technologies LLCFoot (feet)Jack-knifed or overturned, nonroadway
An employee was driving a forklift when it passed over a fiberglass grate and fell into a water capture pit below, tipping sideways. The employee's leg was pinched between the grate and the forklift, and the employee suffered three broken bones in the left foot.
2021-09-25KatyTxCVSHip(s)Fall on same level due to tripping over self
An employee was working in the retail area of a store when she fell, resulting in a broken hip.
2021-09-11KatyTxHy-Tek Material Handling, Inc.Fingertip(s)Struck by falling object or equipment
An employee was installing an I-beam, lining up a pin to insert into a bolt hole. The I-Beam tipped, struck one of his fingers, and amputated the tip. The employee was hospitalized.
2021-08-20KatyTxAIM & N Graphic Solutions LLCHead and trunkIndirect exposure to electricity, greater than 220 volts
An employee was in an aerial lift's metal bucket, installing a banner on the side of a building. The employee finished placing the banner and pulled back to take a picture. The aerial lift came into contact with a power line; the employee was shocked, suffering second-degree burns to the chest and head.
2021-08-03KatyTxSouthern Glazers Wine & SpiritsAnkle(s)Pedestrian struck by vehicle backing up in nonroadway area
A stand-up order picker backed into an employee who was picking up cases of liquor. The employee's left ankle was pinned between a pallet on the picker and one on the ground. The ankle was broken.
2021-06-15KatyTxAcademy, LTDThigh(s)Fall on same level due to tripping over an object
An employee was getting out of her chair when she tripped over the base of her chair and fell to the floor. She suffered a broken femur and was hospitalized.
2020-09-19KatyTxJovito RubioKnee(s)Other fall to lower level
On September 19, 2020, an employee fell while descending a ladder from a roof and landed on a concrete floor. The employee suffered a fractured knee.
2020-08-29KatyTxEmpire Steel Erectors, LPBODY SYSTEMSExposure to environmental heat
An employee had been setting long span girders, welding, and adding X-bracing in the gym area. The employee was hospitalized due to heat stress.
2020-08-06KatyTxCenterPoint Energy EntexAbdomen, except internal location of diseases or disordersFall or jump from and struck by another vehicle in normal operation, nonroadway
An employee was scanning his badge at the card reader to open a gate when he fell from his vehicle and was run over by a truck, leading to internal injuries to his spleen and kidney. The employee was hospitalized and had surgery for his injuries.
2020-05-01KatyTexasAcademy Sports & OutdoorsHip(s)Nonroadway collision with object other than vehicle, n.e.c.
An employee was operating a double-length walkie rider pallet jack. While turning into a lane, the pallet jack struck a support beam; the employee was thrown off and fell 3 feet to the floor, suffering a broken hip.
2020-04-10KatyTexasH-E-BFingertip(s)Struck against moving part of machinery or equipment
An employee was using a band saw to cut meat. The saw amputated the tip of the employee's right middle finger.
2020-03-03KatyTexasNew EarthLower leg(s)Other fall to lower level less than 6 feet
Two employees were fixing and troubleshooting a machine. One of them was on a ladder on top of a belt that needed to be replaced, 3.5 feet high. The machine was activated and the belt moved the ladder, causing the employee to fall to the ground and injure his lower right leg.
2019-09-04KatyTexasAlleyton Resource Company, LLCFingertip(s)Contact with objects and equipment, n.e.c.
An employee had just filled a water tank in a plant. After he removed the hose, the employee used his left middle finger to check the seal on the tank. As he was removing his finger from the tank and simultaneously stepping down from the work platform, he ring was caught in the tank and the left middle fingertip was amputated. He was hospitalized.
2019-07-25KatyTexasCapstone Logistics, LLCLeg(s)Caught between rolling powered vehicle and other object
An employee was performing a pre-trip inspection of a pallet jack when it moved forward and pinned his left leg against a guard rail. The employee sustained a broken leg that required surgery.
2019-07-17KatyTexasCWP Asset CorporateNonclassifiableDirect exposure to electricity
An employee was burned by an arc flash while screwing a face-plate onto an electrical gutter.
2019-06-13KatyTexasU.S. Postal ServiceElbow(s)Fall on same level due to tripping over an object
In a postal facility, an employee tripped over the corner of a wooden platform, fell to the ground, and broke her elbow.
2019-03-16KatyTexasIgloo Products CorpFinger(s), fingernail(s)Caught in running equipment or machinery during regular operation
An employee was operating a foam fixture machine and placing lids in the working area when the top of the blow mold machine crushed the employee's right index and middle fingers resulting in surgical amputation of both fingers. The machine was unguarded at the time of the incident.
2019-02-18KatyTexasAcademy Sports and Outdoor StoresNeck, except internal location of diseases or disordersOverexertion in lifting-single episode
An employee collapsed after lifting a boat and was hospitalized with a cervical spine injury.
2018-09-06KatyTexasAutonation Chrysler Dodge Jeep Ram KatyMultiple body partsOther fall to lower level
An employee was working from a 12-foot ladder, pulling parts off a shelf. Two boxes were stuck together; when they gave way, the employee lost his balance and fell to the ground. He suffered contusions to his head, left elbow and left shoulder.
2018-08-30KatyTexasEasthaven, Inc.BODY SYSTEMSExposure to environmental heat
At about 2:30 p.m. on August 30, 2018, an employee was found in his car, having vomited due to heat stress. He was hospitalized.
2018-07-30KatyTexasUSPSBODY SYSTEMSExposure to environmental heat
After finishing a delivery, an employee began experiencing dizziness, shortness of breath, sweating, and a racing heart, possibly heat-related.
2018-07-18KatyTexasStorm Water SolutionsBODY SYSTEMSExposure to environmental heat
An employee was working outside weed eating a pond area when he became dizzy and unresponsive due to heat stress and dehydration.
2018-07-02KatyTexasAcademy Sports and OutdoorsMultiple trunk locationsPart of occupant’s body caught between vehicle and other object in nonroadway transport incident
An employee was operating a walkie pallet jack to pick up a load when she turned the pallet jack sharply. The pallet jack then increased speed and threw her into a support beam. She was pinned between the pallet jack and the beam, and as she attempted to get un-stuck, she accidentally hit the accelerator, causing the pallet jack to strike her again. She suffered a laceration to the right leg, pelvic fracture, and fracture to the L5 vertebra.
2018-07-01KatyTexasBuc-ee's, LTDNonclassifiableFall on same level due to tripping over an object
An employee was pressure washing the sidewalk, tripped over the hose, and fell. The employee was hospitalized.
2018-04-09KatyTexasFD ProductionsBack, including spine, spinal cordOverexertion in lifting-single episode
An employee and a coworker were lifting pieces of a stage and stacking them on a cart when the employee felt sharp pain in his back and collapsed onto his side. He was hospitalized.
2017-06-26KatyTexasFrontier Title CompanyLeg(s)Other fall to lower level
An employee was climbing a ladder and fell resulting in a broken leg.
2017-05-02KatyTexasITG Communications, LLCBODY SYSTEMSExposure to environmental heat
An employee was helping to dig a shallow trench to bury a cable line when he started having muscle cramps. He was hospitalized for heat stress.
2017-03-18KatyTexasSolutions Staffing Group, LLCArm(s)Pedestrian struck by forward-moving vehicle in nonroadway area
An employee was in the parking lot after work and was stuck by a car resulting in a laceration to her arm.
2017-02-22KatyTexasObed CarlonFinger(s), fingernail(s)Injured by slipping or swinging object held by injured worker
On February 22, 2017, at approximately 4:00 PM, an employee was operating a circular saw to cut a small block of a 2x4 when the saw amputated his left thumb.
2017-01-28KatyTexasDaymon World WideAnkle(s)Fall on same level, n.e.c.
An employee was handing out food samples at the store, fainted and fell to the floor fracturing an ankle.
2017-01-18KatyTexasHouston Methodist HospitalHeadFall on same level due to slipping
An employee slipped on a damp floor and fell backward, striking her head on the wall as she fell. She suffered a head contusion and was hospitalized.
2016-08-17KatyTexasSimonton Windows & DoorsLeg(s)Other fall to lower level 6 to 10 feet
An employee was standing on a 16-foot A-frame ladder replacing an insulated glass unit (IGU) at a private home. He was standing about 10 feet up on the portable ladder when he was exposed to a gust of high wind. He lost his balance and fell to the ground, breaking two bones in his left leg. He was hospitalized for surgery.
2016-08-05KatyTexasIgloo Products CorpFingertip(s)Caught in running equipment or machinery during regular operation
An employee was in the process of attaching handles to a 30-quart cooler when her hand was caught on a piston, amputating her right middle fingertip.
2016-07-08KatyTexasIgloo ProductsFoot (feet)Part of occupant’s body caught between vehicle and other object in nonroadway transport incident
An employee lost control of a forklift, ran into the dock door rail protector, and smashed his left foot.
2016-06-24KatyTexasKaty Steel Company, Inc.FaceStruck by swinging or slipping object, other than handheld, n.e.c.
An employee was moving an overhead crane and had the crane remote in his hand. He was lifting a bundle of rebar with the crane. There was another free-swinging chain hanging from the crane. The hook at the end of the free-swinging chain hit the employee in the face, crushing the right side.
2016-06-16KatyTexasIgloo Products Corp.Toes(s), toenail(s)Struck by falling object or equipment
An employee was gathering tools to clean the screw barrel part of the molding machine when something fell on top of the employee's left-foot, big toe. The employee was hospitalized and had surgery.
2016-05-06KatyTexasDP South Texas Plumbing Co Inc.Finger(s), fingernail(s)Caught in running equipment or machinery during regular operation
An employee was cutting a piece of galvanized pipe with a chop saw and amputated the tip of his left index finger above the knuckle.
2015-08-19KatyTexasWal-Mart #768Ankle(s)Fall through surface or existing opening less than 6 feet
An employee was hospitalized when she stepped into a floor opening and fell. She was cleaning the deli area with coworkers. The floor drain was removed for cleaning purposes. She required surgery for her injured right ankle.
2015-05-22KatyTexasBlack-Eyed PeaFinger(s), fingernail(s)Struck against moving part of machinery or equipment
An employee was working on an A/C unit when the blade struck his right hand little finger.
2015-04-09KatyTexasSource Point Solutions,LLCArm(s)Other fall to lower level 11 to 15 feet
An employee was attempting to climb out of the bottom of a lift station when he fell more than ten feet from a fixed ladder landing on his arm at the bottom of the station. The employee was hospitalized.
2015-04-03KatyTexasAcademy, Ltd.Ankle(s)Part of occupant’s body caught between vehicle and other object in nonroadway transport incident
On or about April 3, 2015, at approximately 10:30 p.m., an employee was operating a pallet rider in the warehouse when his ankle got caught between the pallet rider and a post. He suffered a left ankle fracture and was hospitalized.
2015-03-14KatyTexasAcademy, Ltd.Fingertip(s)Caught in running equipment or machinery during maintenance, cleaning
An employee was conducting maintenance repair on a conveyor system that transports product throughout the distribution facility. The employee's right ring fingertip was amputated when he attempted to remove a chain from a motor sprocket that drove the conveyor system.
2015-03-11KatyTexasInnovative Energy ServicesFinger(s), fingernail(s)Compressed or pinched by shifting objects or equipment
On 3/11/2015, at approximately 8:30 AM, an employee was injured when the tank load he was unloading shifted on his forklift. His finger got caught between the forks and the load when he reached in to secure it. He was taken to the hospital and received surgery.
2015-01-26KatyTexasAUC Group, L.P. Back, including spine, spinal cordPedestrian struck by vehicle backing up in nonroadway area
A temporary worker for AUC Group (worker #1) was walking to his truck to leave for the day. Another worker for AUC Group (worker #2) was backing out a truck owned by AUC Group. Worker #2 struck worker #1 with the vehicle. Worker #1 sustained back injuries caused by the accident, which required a surgical procedure to repair the damage. Worker #1 spent one night in the hospital.