DateCityStateEmployerBody PartEvent
2021-05-13ByramMsWillow Creek Nursing and RehabilitationNeck and backFall on same level due to slipping
An employee fell on a wet floor, suffering back and neck injuries.
2020-08-31ByramMsAdvanced Drainage SystemsHip(s)Other fall to lower level
An employee was securing a load on a tractor trailer. He fell to the ground, suffering a broken hip. He was hospitalized.
2020-08-10ByramMsDarling Ingedients, Inc.NonclassifiableContact with hot objects or substances
Two employees were performing maintenance on a hydrolyzer when steam released. Both employees were hospitalized with burns.
2019-08-08ByramMississippiAdvanced Drainage Systems, Inc.Fingertip(s)Caught in or compressed by equipment or objects
An employee was assisting a supervisor to clear jammed material from a machine. A 40-pound knife blade moved and amputated the employee's right index fingertip.
2019-06-22ByramMississippiNCI Group, Inc.Fingertip(s)Caught in running equipment or machinery during regular operation
A maintenance employee was completing work on a metal shaft that was in a milling machine. The employee turned the milling equipment on and was polishing the end of the rotating shaft with a piece of emery cloth. During the process, his glove or the emery cloth wrapped around the rotating shaft, pulling his hand onto the shaft. He suffered a dislocation to his left little finger, as well as an avulsion and partial amputation to a left distal fingertip.
2019-04-18ByramMississippiNCI Group, Inc.Finger(s), fingernail(s)Caught in running equipment or machinery during maintenance, cleaning
An employee was attempting to clean the applicator rollers on a coil coating machine when the employee's right fingers were caught between the in-going rollers. The employee was hospitalized and sustained amputations to the right small, ring, and middle fingers.
2019-02-15ByramMississippiUnified Brands, Inc.Fingertip(s)Struck by object falling from vehicle or machinery-other than vehicle part
An employee was trying to repair a machine used to flip kettles. A screw had broken in the pivot block, causing a kettle to get stuck; the employee was using a hoist to lift the kettle to reduce tension in order to remove the kettle. The kettle fell onto his hand, amputating the tip of his right thumb.
2015-08-18ByramMississippiW. E. Blaine and Sons Inc.BODY SYSTEMSExposure to environmental heat
An employee was performing service work on paving equipment outdoors. The employee experienced stomach pain, possibly due to heat stress, and was hospitalized.
2015-07-14ByramMississippiKEY CONSTRUCTORS LLCToes(s), toenail(s)Contact with objects and equipment
An employee's toes on the right foot were amputated after being crushed by a 36 foot long pillar.
2015-07-10ByramMississippiGriffin Industries LLCNeck, except internal location of diseases or disordersStruck against stationary object or equipment
An employee was using a creeper under a truck and hit is head on a steel beam causing a ruptured disk in his neck.
2015-04-13ByramMississippiDuro-Last Roofing, Inc.Finger(s), fingernail(s)Caught in running equipment or machinery during regular operation
An employee was helping a press break operator form a piece of sheet metal for a gutter downspout. The operator and the employee placed the sheet metal into the break press and aligned the markings that were on the sheet metal under the press bar for the proper bends. After the sheet metal was aligned in the press, the operator activated it at the control panel. The employee's right hand was in the press, and his two middle fingers were amputated at the first joint.